ZyXEL Communications Network Card gigabit ethernet line card version 4.02 Uživatelský manuál stáhnout pdf (Strana 23)

Chapter 3 Troubleshooting

GLC1320G-55 User’s Guide

2 Connect your computer to the console port and use terminal emulation software configured to the

following parameters:

3 Pull out the line card and push it back in to restart it and begin a session.

4 When you see the

Press any key to enter Debug Mode within 3 seconds message,

press a key to enter debug mode.

5 Type

atba5 after the Enter Debug Mode message (this changes the console port speed to

115200 bps).

6 Change the configuration of your terminal emulation software to use 115200 bps and reconnect to

the line card.

7 Type

atur after the Enter Debug Mode message.

8 Wait for the

Starting XMODEM upload message before activating XMODEM upload on your

terminal.

9 This is an example Xmodem configuration upload using HyperTerminal. Click Transfer, then Send

File to display the following screen.

Figure 5 Example Xmodem Upload

• VT100 terminal emulation • 9600 bps

• No parity, 8 data bits, 1 stop bit • No flow control

Type the firmware file's

location, or click Browse to

search for it.

Choose the 1K Xmodem

protocol.

Then click Send.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30

Žádné komentáře

ZyXEL Communications Network Card gigabit ethernet line card version 4.02 Uživatelský manuál Strana 23